|Product Name:||Wireless Signal Detector||Detectin Object::||10mW 2.4GHz Wireless Camera 10mW 2.4GHz Wireless Camera Up To 15 Feet|
|10mW 5.8GHz Wireless Camera::||Up To 4 Feet||3G 2100 Cell Network::||Up To 25 Feet|
|Dimension::||L 11.6 X W 7 X T 3.3 Cm (not Include Antenna)||Weight::||About 170g (not Include Battery)|
electronic bug detector,
wireless bug detector
RF Signal Detector with Environment Adaption Lens Finder Expert 3G Detection 50-6Ghz
This wireless signal detector device boots self-detecting voice broadcast but does not affect the state of radio, 8LED signal strength indicator, clear various signal status and battery status, three alarm modes BAV, automatic detection signal category, WIFI identification, battery and charging status, You can find a static bug, detect it in the standby state, and also have a LENS finder. With sensitivity adjustment and volume adjustment and volume adjustment knob. With professional 3G detection.
|2||Vibration||Vibration warning mode (manual shift)|
|3||Beep||Beep sound warning mode (Default)|
|4||Hi Signal||Warning of strong signal in around|
|5||CAM / Bug / LTE||
Analog / Spread spectrum signal of
Camera, bug and cellphone
|6||WiFi||Digital signal of WiFi and IP camera|
|7||Battery low||Battery power running down|
|8||Charging||Status of battery charging|
5. Yellow LED +
6.Blue LED light up
|Detected radio wave of 3G 2100|
HOW TO OPERATE:
1. Pull out the antenna and turn on this device. This device will do power-on self-test and then run power-on environment adaption. After the power-on actions are completed, this device will remain the Power and Beep LED lit up. And then the Yellow and Blue LED will start blinking, indicate this device is in detecting.
2. If more than one strength indication 8-LED lights up and beeps go off (vibrate), it means that there is RF (wireless) device operating around. If Hi Signal LED lights up at the same time, the detected radio wave is very strong.
3. Refer to the chapter of “How to find (locate) the signal source” to find the position of signal source.
4. Press once both the 2 buttons in left side of front view, can change the warning mode cyclically, beep à vibrate à beep à vibrate ...
5. To detect without other’s awareness, set the warning mode at Vibration or connect with earphone for silent detection.
HOW TO FIND (LOCATE) THE SIGNAL SOURCE:
This device can detect and locate new bug and new spy camera remote controlled by cellphone.
Detect GPS tracker (2G / 3G / 4G Multi networks modem):
RF Bug Detector
|2.||Switching power adaptor x 1|
|3.||Earphone x 1||4.||Rechargeable batteries x 4 (optional)|
|5.||USB-Mini USB cable x 1||6.||Lens Finder x 1|
Contact Person: Ms. Jena